Cinema 4D 每日一练 | 2021-11-28

In the front view perspective, shift +v -> back -> image -> upload the reference picture.

adjust the offset to position the center along the axis.

- use polygon pen tool, instead of spline pen tool. create as less points as possible, the subdivision surface would finish all the job.

- choose live selection tool, set position value of the points on the axis to 0 cm,use symmetry generator to finish the other half part.

create subdivision surface generator, and put symmtry as it's child.

resize the points in point mode in front view perspective.

use loop cut tool to cut a loop close to the curve point to make the curve shaper.

use the slide tool to resize the mesh. then select all the polygon, in the polygon mode to use extrude tool to make the thickness. remember to check the Create Caps option when extruding.

to remove the manifold polygons, go to the symmetry object attribute manager, and check Clapm Points on Axis and Delete Polygons on Axis.

then the manifold polygons would be removed. then check the Create Caps in the extude object.

create a material object, choose the bright red color, make the specular strength higher and it's width lower in the Reflectance Tab.

Drag the Material ball onto the subdivision surface object.

select points in the middle on both front and back sides, then use scale tool to make some extrusion effect.

final result, not bad.